Welcome to Your Water Chiller Setup Guide!

We’re excited to help you get your Water Chiller up and running for a refreshing, perfectly chilled ice bath experience. Follow these easy steps to ensure a smooth installation and optimal cooling performance.

Step 1: Unbox & Stabilize

• Carefully unpack all hoses and equipment.

• Allow the chiller to sit undisturbed for 2-6 hours so the internal gases can stabilize, just like a refrigerator.

Step 2: Find the Perfect Spot

• Place the chiller in a well-ventilated area, where you plan to use it, to ensure efficient cooling.

Step 3: Fill with Water

• Fill the chiller with water to the recommended level for optimal cooling.

Step 4: Secure Water Connectors

• Double-check that both water connectors on top of the chiller are tightly attached. Use the sealing rings provided.

• Be careful not to over-tighten to avoid damaging the connectors.

Step 5: Connect the Hoses

• Connect the 2-meter hose to the water connector using the clamps provided.

• Attach the 1-meter hose to the opposite water connector in the same way.

• Place the free end of the 2-meter hose into your ice bath (or use an additional valve if available).

Step 6: Set Up the Water Pump

• Fill the 1-meter hose with water and connect it to the water pump.

• Ensure the arrow on the pump points toward the chiller for proper flow.

Step 7: Assemble the Filter

• Connect and fill the filter assembly with water. The pump will start automatically when water is detected.

• Attach the 0.4-meter hose to the filter, filling it with water.

• Make sure no air remains in the hose or filter to prevent any blockages.

Step 8: Connect to Your Bath

• Attach the hose to your ice bath’s connector or simply place it in the water.

• If you’re using a different setup (like a bathtub, jacuzzi, or ice barrels), submerge the hose ends in the water to start circulating.

Step 9: Power Up

• Plug in both the chiller and water pump to separate sockets.

• Power them on and let them run to begin cooling.

Important Notes:

• The water pump is designed to push water efficiently. Keep it positioned below or close to the tub for consistent pressure.

• Make sure to fill the chiller with water before connecting the hoses, pump, and filter.

• Always ensure all components (pump, hoses, chiller, and filter) are filled with water to avoid damage.

Need Help?

If you have any questions or run into any issues during setup, we’re here to assist. Don’t hesitate to reach out for support. At SubZero Ice Baths, we’re dedicated to providing you with the best possible cooling experience (info@subzeroicebaths.net)

Thank you for choosing SubZero Ice Baths! Enjoy your perfectly chilled water!